CCNA dump answers

jasonkaku · Post time 17-2-2021 15:47:04

The answers of the following five questions are inconsistent with those of other dump. I‘m eager to ask the boss to give me the right choice. Thank you

What is a difference between local AP mode and flexconnect AP mode?

A. Local AP mode creates two CAPWAP tunnels per AP to the WLC

B. Local AP mode causes the AP to behave as if it were an autonomous AP

C. FlexConnect AP mode fails to function if the AP loses connectivity with the WLC

D. FlexConnect AP mode bridges the traffic from the AP to the WLC when local switching is configured

Answers A

other answers D

Question 2. Refer to the exhibit. A router received these five routes from different routing information sources. Which two routes does the router install in its routing table?

(Choose two)

A. OSPF route 10.0.0.0/30

B. IBGP route 10.0.0.0/30

C. OSPF route 10.0.0.0/16

D. EIGRP route 10.0.0.1/32

E. RIP route 10.0.0.0/30

Answer CD

Refer to the exhibit. An engineer configured NAT translations and has verified that the configuration is correct. Which IP address is the source IP after the NAT has taken place?

A. 10.4.4.4

B. 10.4.4.5

C. 172.23.103.10

D. 172.23.104.4

Answers D

What is a function of TFTP in network operations?

A. transfers IOS images from a server to a router for firmware upgrades

B. transfers a backup configuration file from a server to a switch using a username and password

C. transfers a configuration files from a server to a router on a congested link

D. transfers files between file systems on a router

Answers D

Refer to the exhibit. If the network environment is operating normally, which type of device must be connected to interface FastEthernet 0 / 1?

A. DHCP client

B. access point

C. router

D. PC

Answers D

Question 2