On the reconstruction of Linux rdia

shuneng

A RAID1 made by Lenovo before r510 G7 was found to be broken recently. Entering the RAID configuration interface, it shows that the array has been degraded. If the broken disk is pulled out, it is OK for a single disk to enter the system, so it is shut down and replaced with a fast disk of the same capacity, the same brand and different models. When it is turned on, the raid status is rebuilt, but there is no progress display, and the hard disk light is always on, as shown in the figure

(93.62 KB, 0 downloads)[/I]

Upload at 16:09, 2021-1-14