|
|
Which two command sequences must you configure on a switch to establish a Layer 3 EtherChannel with an open-standard protocol?( choose two) A. interface GigabitEthernet0/0/1
Channel-group 10 mode active
B. interface GigabitEthernet0/0/1
Channel-group 10 mode auto
C. interface GigabitEthernet0/0/1
Channel-group 10 mode on
D. interface port-channel 10
no switchport
ip address 172.16.0.1 255.255.255.0
E. interface port-channel 10
switchport
Switchport mode trunk
Why is ad not AE
|
|
English
Post time 9-6-2021 17:17:29
